Make sure your sequencer can properly chase MTC code... many hardware sequencers do not... they only chase SPP or midi clock... which is a very loose protocol.
SAWStudio uses Smpte or MTC... you can use hardware midi boxes that will read smpte and convert to midi clock with SSP for position start information... but...
How about dumping all your midi tracks directly into the Midi Workshop add-on for SAWStudio... you can record them all at once usually since most sequencers seem to put each track on a separate midi chan... the MWS has a multi-record mode that will automatically split each midi channel to a different track.
Playing back the midi data with MWS will give you perfect sync everytime.
Bob L
SAWStudio uses Smpte or MTC... you can use hardware midi boxes that will read smpte and convert to midi clock with SSP for position start information... but...
How about dumping all your midi tracks directly into the Midi Workshop add-on for SAWStudio... you can record them all at once usually since most sequencers seem to put each track on a separate midi chan... the MWS has a multi-record mode that will automatically split each midi channel to a different track.
Playing back the midi data with MWS will give you perfect sync everytime.
Bob L
另外早前 dabeat 在睡夢中傳功, 說了在 reason 和 albeton 和 saw 的大概設置, 不過還是建議分別用兩部電腦來拖比較好, 因為負苛大。
in MIDI input.....remember to click "SPP" Song Position Pointers
in Timeline.....set Tempo Mode
Smpte/Midi "Genarate MTC Sync"
Timeline - > Termpo Settings - > Ticks Resolutions -> 384 Ticks per Quarter Note
n Albeton Live/ Reason, not much too setup....just use check the "SPP" and same 384 ticks....should work....
need to sure the "Track" inported Metronome is alive...
may use a blank track fill it.
right click the Metro. choose "Generate Midi Clock"
set the correct Midi out.
use 2 PCs to try, 1 use SAW, 1 use Ableton Live, after everything work...remember the settings....
something like "Build" a blank 5 mins sound file in Track 1, and use the Mertro plugin @ there.
in MIDI input.....remember to click "SPP" Song Position Pointers
in Timeline.....set Tempo Mode
Smpte/Midi "Genarate MTC Sync"
Timeline - > Termpo Settings - > Ticks Resolutions -> 384 Ticks per Quarter Note
n Albeton Live/ Reason, not much too setup....just use check the "SPP" and same 384 ticks....should work....
need to sure the "Track" inported Metronome is alive...
may use a blank track fill it.
right click the Metro. choose "Generate Midi Clock"
set the correct Midi out.
use 2 PCs to try, 1 use SAW, 1 use Ableton Live, after everything work...remember the settings....
something like "Build" a blank 5 mins sound file in Track 1, and use the Mertro plugin @ there.