- 第 1 页 -
跑得那麼快啊.....!!
還有下文的
The data next passed through the EQ routines. There are five high-resolution bandpeaking filters that can be adjusted independently or all at the same time. Each filter includes an overlapping frequency center from 40 to 15,000 hertz. The Q or bandwith adjustment ranges from 0.1 to 3 octaves, and the boost/cut gain ranges from plus to minus 15DB.
There is a also a Hi Cut filter that ranges fro, 15,0000 to 20000 hertz which attenuates frequencies above the filter setting using an 18db oer octave rooll-off.
There is also a Lo Cut filter that ranges from 40 to 2000 hertz whcih attenuates frequencies below the fillter setting using an 18db per octave roll-off.
A set of graphic adjustiable bars can be used for quick boost and cut adjustment, much like a simple of graphic EQ sliders.
At the bottom of the EQ section is a Reset Flat switch which resets all gain adjustments to flat and the master EQ In/Out switch to allow for quick bypass of the EQ routines for comparison or for use in automating the EQ in and out if the mix.
All EQ settings may be automated.
[ 本帖最后由 himhui 于 07-9-24 18:12 编辑 ]
還有下文的
The data next passed through the EQ routines. There are five high-resolution bandpeaking filters that can be adjusted independently or all at the same time. Each filter includes an overlapping frequency center from 40 to 15,000 hertz. The Q or bandwith adjustment ranges from 0.1 to 3 octaves, and the boost/cut gain ranges from plus to minus 15DB.
There is a also a Hi Cut filter that ranges fro, 15,0000 to 20000 hertz which attenuates frequencies above the filter setting using an 18db oer octave rooll-off.
There is also a Lo Cut filter that ranges from 40 to 2000 hertz whcih attenuates frequencies below the fillter setting using an 18db per octave roll-off.
A set of graphic adjustiable bars can be used for quick boost and cut adjustment, much like a simple of graphic EQ sliders.
At the bottom of the EQ section is a Reset Flat switch which resets all gain adjustments to flat and the master EQ In/Out switch to allow for quick bypass of the EQ routines for comparison or for use in automating the EQ in and out if the mix.
All EQ settings may be automated.
[ 本帖最后由 himhui 于 07-9-24 18:12 编辑 ]
没有特色最难！原帖由 成功 于 07-9-24 17:27 发表
我发现SAW的EQ很好！今天我心血来潮，想试试EQ作为房间均衡器的效果。把我的听音室频响用不同的EQ来拉直。因为我也经常听远场音箱播放音乐。我用SAW播放音乐，按照我已知房间曲线调整好各种EQ软件进行对比，结果 ...
SAW的Ｑ值就是倍频值 比如默认就是１．５倍频 而很多其它ＥＱ的Ｑ值与倍频呈倒数关系 １０为０．１倍频 ０．３３为３倍频.......
大体是这两种情况 但有的或许设计上独特 比如带一点谐波算法...又或者设计成多风格类型了 其Ｑ值就可能不用常规值表达 个性化．
[ 本帖最后由 lvcha 于 07-9-24 20:53 编辑 ]