- 第 2 页 -
原帖由 afj 于 07-3-14 13:48 发表
回himhui大大，9632和poco pci使用正常；就是开机后必须重起一遍才能认到poco，以前的P4也是这样。
找了兩個較像樣的方法, 但也不一定成功的:-
1) shortly after switching on your computer hit reset or ctrl-alt-del. the POWERCOR should then be correctly recognized and the driver will be loaded.
當一開機時, 馬上按 ctrl-alt-del (或 重起按鈕掣)
2) The issue is due to the speed of the power-up cycle of the computer - they're just getting sooo fast! The PoCo sometimes takes a little longer...
If you have an option to "slow boot" this may relieve the issue.
由於起機速度太快, 如果有的話, 可嘗試在 BIOS 選擇 "SLOW BOOT"(慢起機)
[ 本帖最后由 himhui 于 07-3-15 09:19 编辑 ]