老版本有，改进后就取消了
有關包絡
Volume Curves
SAW uses a concept for volume & panorama curves that is different from other formats: it writes every point of a transition into its session file, i.e. for a linear fade it writes every point of the straight line. This is why you can end up with a huge number of points in your SAW edl. This can be a problem when converting to Cool: Cool's number of volume points is limited to 127 per region. Therefore EDL Convert reduces the number of points; for example, a linear fade can have 320 points in SAW whereas in Cool there are only 2 points needed.
SAW使用的音量和声像曲线的原理是一种完全不同的类型：它把每一个数值的变化点写入Session文件，也就是说，如果是直线衰减，它会记录直线上的每一个点。这就是在SAW工程文件中可以用非常非常多的点来作渐变结束的原因。同样的状况如果转换到Cool中就会有问题：在Cool中每个区域中的音量记录点限制在127个以内。所以工程文建的转换会减少记录下点的数量；例如，一个直线衰减在SAW中大概有记录下320个点而在Cool中只需要2个。 (小馬翻譯)
[ 本帖最后由 himhui 于 07-7-5 14:30 编辑 ]
Volume Curves
SAW uses a concept for volume & panorama curves that is different from other formats: it writes every point of a transition into its session file, i.e. for a linear fade it writes every point of the straight line. This is why you can end up with a huge number of points in your SAW edl. This can be a problem when converting to Cool: Cool's number of volume points is limited to 127 per region. Therefore EDL Convert reduces the number of points; for example, a linear fade can have 320 points in SAW whereas in Cool there are only 2 points needed.
SAW使用的音量和声像曲线的原理是一种完全不同的类型：它把每一个数值的变化点写入Session文件，也就是说，如果是直线衰减，它会记录直线上的每一个点。这就是在SAW工程文件中可以用非常非常多的点来作渐变结束的原因。同样的状况如果转换到Cool中就会有问题：在Cool中每个区域中的音量记录点限制在127个以内。所以工程文建的转换会减少记录下点的数量；例如，一个直线衰减在SAW中大概有记录下320个点而在Cool中只需要2个。 (小馬翻譯)
[ 本帖最后由 himhui 于 07-7-5 14:30 编辑 ]
