M-Audio将Torq升级到Torq 1.0.4。新版本得到了Mac 10.4.9和Windows XP SP2的支持。
变化：
- Supports Xponent controller/interface.
- Holding SHIFT and rotating an Xponent Scratch Wheel will offset the Phase Grid.
- Redesigned MIDI architecture for improved response.
- If a sample is looped, it will be looped when used with QuickScratch. If a sample is not looped, it will not be looped when used with QuickScratch.
- Hide Phase Grid button will remove the Phase Grid from the Scrolling Waveforms.
- New “Reset Speed Slider on New Track” preference for keeping the position of the Speed Slider the same when loading a new song.
- The Sampler will use the phase information of the Master Tempo when recording from the Line-Input.
- MIDI control can be assigned to the scrolling waveforms (for scratching with a device other than Xponent).
- Torq will remember the path when saving samples.
- Fixed: Track will play without External Control if dropped onto a Deck while Runout Protection is active.
- Fixed: Two additional Snapshots on top of a Key Change Snapshot will cause incorrect Key behavior.
- Fixed: VST Effects unstable when Effect Rack is Bypassed.
- Fixed: When a Deck is synced to the other Deck, the Reverse effect stutters and skips when activated.
- Fixed: Schaffel mode not implemented for all effects.
- Fixed: Snapshot recalls incorrect Repeat Size.
- Fixed: Snapshots are affecting parameters outside their scope.
- Fixed: Sync is not disabled when loading a track onto the opposite Deck.
- Fixed: Playing back a sampled loop results in audio glitch.
- Fixed: When activating a QuickScratch, the previous loop would superimpose itself on the sample.
- New preference for resetting Speed Slider on new song.
点击这里下载
[
本帖最后由 margindge 于 07-5-18 23:08 编辑 ]