本帖最后由 翻版货 于 16-11-22 19:47 编辑
哪个按钮可以控制34路的音量？好像。反而12路可以控制音量。而34路不受旋钮控制
bobo198504 发表于 16-11-21 10:51
3，4路有独立的音量控制，默认应该就是最大的
哪个按钮可以控制34路的音量？好像。反而12路可以控制音量。而34路不受旋钮控制
bobo198504 发表于 16-11-23 18:57
你的声卡就是四出的，如果不知道这样设计的作用是什么，为什么要买四出的呢，两出就够用了
我只为了能多接一对音箱。
bobo198504 发表于 16-12-4 19:04
那你看看能不能通过软调音台设置1/2和3/4联动控制音量，不行就没办法了，多通道当然是分开控制的，一起控制 ...
感谢
3 4 是按照最大音量输出的
所以 把monitor旋钮 开到最大 所有音量才会一致
官网有文档说过这个问题
Line Outputs 3 & 4 are louder than Line Outputs 1 & 2 on my Scarlett 2i4
This applies to the Scarlett 2i4
If you're using your unbalanced line outputs to send audio to an external mixer from your Scarlett 2i4 and you notice that outputs 3 & 4 are louder than outputs 1 & 2 this may be due to your monitor knob setting on the front of your 2i4. It's important to remember that volume for both balanced and unbalanced outputs 1 & 2 are controlled by your monitor knob on the front of your 2i4. Therefore if you're experiencing less signal from outputs 1 & 2 than 3 & 4, make sure that your monitor volume is set the maxium output volume to ensure that both sets of unbalanced outputs are sending equal volume levels to the two channels on your external mixer. This is essential when using your 2i4 for djing as having unqual input volumes could cause uneven levels when crossfading from track to track.
https://support.focusrite.com/hc ... -on-my-Scarlett-2i4
所以 把monitor旋钮 开到最大 所有音量才会一致
官网有文档说过这个问题
Line Outputs 3 & 4 are louder than Line Outputs 1 & 2 on my Scarlett 2i4
This applies to the Scarlett 2i4
If you're using your unbalanced line outputs to send audio to an external mixer from your Scarlett 2i4 and you notice that outputs 3 & 4 are louder than outputs 1 & 2 this may be due to your monitor knob setting on the front of your 2i4. It's important to remember that volume for both balanced and unbalanced outputs 1 & 2 are controlled by your monitor knob on the front of your 2i4. Therefore if you're experiencing less signal from outputs 1 & 2 than 3 & 4, make sure that your monitor volume is set the maxium output volume to ensure that both sets of unbalanced outputs are sending equal volume levels to the two channels on your external mixer. This is essential when using your 2i4 for djing as having unqual input volumes could cause uneven levels when crossfading from track to track.
https://support.focusrite.com/hc ... -on-my-Scarlett-2i4
观众反应